RAD Data comm LRS-24 - Manual (Page 104)

Appendix D CM-2 Management Commands LRS-24 Installation and Operation Manual
D-2 Defining Dial-Up Modem Parameters
D.1 Defining Dial-Up Modem Parameters
Purpose
Defines the call-out parameters for the CM-2 dial-out port. The specified call-out
parameters are used by the CM-2 to build the call command that is sent to the
dial-up modem.
The modem connected to the out port must be set up as follows: (For
convenience, the Hayes commands required to select the specified parameters are
listed in brackets.)
• At least 38.4 kbps per second dial modem
• Modem reports call progress result codes: OK, CONNECT, RING,
NO CARRIER, NO ANSWER, ERROR, BUSY (AT X0)
• Modem sends result code to DTE (AT Q0)
• No echo (AT E0)
• Modem sends long form result codes (AT V1)
• DTR is ignored (AT &D0)
• DSR forced on (AT &S0)
• Escape code character must be + (AT S2=43).
Format
DEF CALL
Procedure
➤ To define the CM-2 call-out parameters:
• Type: NODE 13 DEF CALL<Enter>.
The call-out parameters’ data form is displayed. A typical data form is shown in
Table D-1.
DIAL MODEM CONFIGURATION
DIAL MODEM STATUS: ACTIVE
COMMAND: ATD
NUM OF RETRIES: 2
WAIT FOR CONNECT: 60 SECS
DIAL MODE: TONE
PHONE NUMBER: 29
ALT NUM MODE: YES
ALT NUM:
Figure D-1. Dial Modem Configuration Screen
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com