RAD Data comm LRS-24 - Manual (Page 65)

Introduction 4-1
Chapter 4
Management via the CM-2
Module
The information presented in this chapter includes:
• CM-2 functions
• Description of supervision terminal hardware requirements, and of methods
for connecting a supervision terminal or network management station to
LRS-24
• Supervision terminal commands
• Supervision terminal operating instructions.
The instructions appearing in this chapter assume that the supervision terminal
operator is familiar with the configuration parameters of the modules installed in
LRS-24.
4.1 Introduction
This chapter describes how to use a supervision terminal to manage an LRS-24
enclosure that contains a CM-2 control logic module.
The CM-2 module also enables management of the LRS-24 system by means of a
RADview network management station, or other SNMP-based network
management station. For information regarding the use of the RADview network
management station, refer to the RADview User's Reference Manual.
CM-2 Module Capabilities
The CM-2 module includes an internal SNMP agent, and therefore it requires
preliminary configuration. The preliminary configuration of LRS-24 must always be
performed using a standard ASCII terminal connected to the CM-2 front panel
supervisory port, designated MANAGEMENT RS-232. You can use terminals of the
following types: VT-52, VT-100, TV-920, FREEDOM-100, FREEDOM-110,
FREEDOM-220, or other terminals that are fully compatible with one of these
terminals.
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com