RAD Data comm LRS-24 - Manual (Page 137)

LRS-24 Installation and Operation Manual Appendix D CM-2 Management Commands
Displaying I/O Module Alarm Status D-35
D.14 Displaying I/O Module Alarm Status
Purpose
Displays the status and the alarms for a specific I/O module.
This command is relevant only for I/O modules that do not support direct
management by SNMP or by supervision terminal, for example, ASMi-24,
ASMi-30, ASMi-31, ASMi-32, etc. For such modules, the CM-2 module provides
the terminal interface.
Format
NODE nn DSP ALT
Procedure
➤ To d isplay I/O Module Alarm Status:
• Type: NODE nn DSP ALT <Enter>.
nn stands for the node number of the desired module, in the range of
1 through 12.
The status and alarm display form for the specified module appears.
The contents of the form depend on the module type.
Refer to the Installation and Operation Manual of the corresponding module for
detailed information.
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com