RAD Data comm LRS-24 - Manual (Page 107)

LRS-24 Installation and Operation Manual Appendix D CM-2 Management Commands
Defining LRS-24 And CM-2 SNMP Agent Parameters D-5
3. Press <Tab> to move to the next field.
4. Continue until all the required lines have been filled in.
SNMP community names are case-sensitive.
5. Press <Enter> to load all the data appearing on the screen into the CM-2
memory.
A typical data form is shown in Figure D-2.
LRS HUB SETUP
HUB NAME : 'name'
HUB NUMBER : '1234'
HUB LOCATION IS : 'location'
CONTACT PERSON IS : 'person'
CM CARD SOFTWARE VER : 0.0 MAIN CARD HW REV : VER 2.0
INTERFACE CARD HW REV: 0.0
TIME (HH:MM:SS) : 16:18:37 DATE : 2000-05-23
IP ADDR : 192.114.24.30 IP MASK : 255.255.255.0
READ COMMUNITY : PUBLIC
TRAP COMMUNITY : PUBLIC
READ/WRITE COMMUNITY : PUBLIC
DEFAULT GATEWAY : 000.000.000.000
BURN IN MAC ADDRESS : 9920D2FE838D BOOTP ON/OFF : OFF
BOOTP TIME OUT : 1 SEC BOOTP RETRIES : 30
HUB IP MODE : MULTIPLE
SERIAL LINE PROTOCOL : RS232
STATION CLOCK : INTERNAL CLOCK
Figure D-2. LRS Hub Setup
Command Fields
Table D-2 describes fields on the data form.
Table D-2. DEF HUB Command Fields
Field Name Description Options
HUB NAME Logical name assigned to the LRS-24 unit. Maximum 10 alphanumeric
characters
Default: LRS-24
HUB NUMBER LRS-24 management number. The two least
significant digits are displayed on the STAT/ADD
display located on the front panel of the CM-2
module.
Mmaximum four hexadecimal
digits
Default: 5544
Note
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com