RAD Data comm LRS-24 - Manual (Page 129)

LRS-24 Installation and Operation Manual Appendix D CM-2 Management Commands
Defining Auto-Configuration D-27
Send process: [size] byte transferred
The send process was completed successfully.
Figure D-26. Send Process Confirmation Screen
Editing a Modem File
➤ To configure a modem file:
1. Type 1 from the Auto-Configuration Menu.
The Edit Configuration screen appears (see Figure D-23).
2. Choose:
− NEW: a screen appears with all the fields listed as N/A (see Figure D-27)
− 1, 2, or 3: a screen appears with the parameters from the file you have
selected.
EDIT AUTO-CONFIGURATION
PARAMETERS:
SYNC/ASYNC : N/A CHARACTER LENGTH : N/A
No. STOP BIT : N/A DATA RATE : N/A
PARITY : N/A CD SENSE : N/A
CLOCK SOURCE LOC/REM : N/A EXT SOURCE : N/A ALL PORTS : N/A
INTERFACE : N/A RTS/CTS DELAY (0.255) : N/A
RTS TO DCD : N/A DTR TO DSR : N/A
OUTPUT LEVEL : N/A INPUT LEVEL : N/A
OUTPUT IMPEDANCE : N/A ohm INPUT IMEDANCE : N/A ohm
CARRIER CONTROL : N/A ERROR CORRCTION : N/A
RATE ADATPTION METHOD : N/A AIS : N/A
LINE CODING : N/A PHANTOM : N/A
T1 LINE LENGTH : N/A
OPERATIONS:
MODEM RESET : DISABLE STOP STATUS UPDATE :DISABLE
CHANGE LOCAL MODEM STATUS : MASTER MANAGEMENT FROM REMOTE MODEM: N/A
MODEM MANAGEMENT LINK : N/A LOAD CONFIGURATION FROM :N/A MODEM
I-TYPE(Far_End Modem type): N/A
Figure D-27. Edit Auto-Configuration for New Modem File
3. Enter information for the parameters.
If you do not enter any parameters, you receive an error message.
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com