RAD Data comm LRS-24 - Manual (Page 121)

LRS-24 Installation and Operation Manual Appendix D CM-2 Management Commands
Defining Card Configuration D-19
D.8 Defining Card Configuration
Purpose
Defines card type, name, and connection to a remote modem.
Format
NODE 13 DEF CRD
Procedure
➤ To define card type, name, and connection:
• Type: NODE 13 DEF CRD <Enter>.
Information about all the cards in the hub is displayed. A typical form is
shown in Figure D-18.
DEFINE CARD TYPE
Slot Type Modem Remote1 Remote2 Remote3 Remote4
Card 1 : EMPTY NULL LINKED LINKED LINKED LINKED
Card 2 : EMPTY NULL LINKED LINKED LINKED LINKED
Card 3 : IMODE ASMi-31CQ(m) LINKED LINKED LINKED LINKED
Card 4 : EMPTY NULL LINKED LINKED LINKED LINKED
Card 5 : EMPTY NULL LINKED LINKED LINKED LINKED
Card 6 : EMPTY NULL LINKED LINKED LINKED LINKED
Card 7 : EMPTY NULL LINKED LINKED LINKED LINKED
Card 8 : IMODE FOMi-E1/T1C(m) LINKED LINKED LINKED LINKED
Card 9 : IMODE ASMi-31C(m) LINKED LINKED LINKED LINKED
Card 10 : IMODE ASMi-24C(m) LINKED LINKED LINKED LINKED
Card 11 : IMODE ASMi-31C(m) LINKED LINKED LINKED LINKED
Card 12 : IMODE ASMi-50C(m) LINKED LINKED LINKED LINKED
Figure D-18. Define Card Type Screen
Each slot number shows the type of modem, name, and connection to a remote
modem.
For parameters Type and Modem:
• If Type is IMODE both fields are read-only.
• If Type is EMPTY you can define Type and Modem name, only when in
Terminal Mode.
• If Type is SMODE you can define Modem name.
Remote1 defines whether the modem is connected to (LINKED) or disconnected
from (UNLINKED) a remote modem. A double modem card, such as
FOMi-E1/T1CD, is defined for two remote modems - Remote1 and Remote2.
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com