RAD Data comm LRS-24 - Manual (Page 138)

Appendix D CM-2 Management Commands LRS-24 Installation and Operation Manual
D-36 Displaying System Status
MODEM ALRAM STATUS
MODEM NAME: ASMI-31CQ(m)
DEFINE MODEM PORT NUMBER : 1
SELECT MODEM : MODEM 2 LOCAL
LINE DISCONNECT : OFF
REMOTE MODEM POWER OFF : OFF
TRANSMIT CARRIER : OFF
RECEIVE CARRIER : OFF
LLB BY DTE : OFF
RLB BY DTE : OFF
SYNC LOSS : ON
CONFIGURATIO MISMATCH : OFF
NVRAM FAILED : OFF
ILLEGAL EXTERNAL CLOCK SOURCE : ON
NO MANGEMENT LINK : ON
NO MODEM PORT (IR) : OFF LAN NOT CONNECTED : OFF
NO FIBER INTERFACE : OFF NO EXT CLK INPUT : OFF
IR RATE MISMATCH : OFF ILL. CLK-ERR : OFF
ELF TEST FAILED : OFF OLD REM VERSION : OFF
XILINX FAILES : OFF WRONG CONNECTION : OFF
MINOR ALARM – AIS-ELC : OFF ASI-OPT : OFF
MAJOR ALARM – LINE DISCON.-ELEC : OFF LINE DISCON.-OPT : OFF
Figure D-39. Modem Alarm Status Screen
D.15 Displaying System Status
Purpose
Displays LRS-24 system information.
This command is always addressed to the CM-2 module. Therefore the node
address must always be 13.
Format
NODE 13 DSP HUB
➤ To display current system information:
• Type NODE 13 DSP HUB <Enter>.
A typical display is shown in Figure D-40.
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com