RAD Data comm LRS-24 - Manual (Page 120)

Appendix D CM-2 Management Commands LRS-24 Installation and Operation Manual
D-18 Defining I/O Module Management Parameters
D.7 Defining I/O Module Management Parameters
Purpose
Defines general operational and access parameters for an I/O module.
This command is relevant only for I/O modules that do not support direct
management by SNMP or by supervision terminal, for example ASMi-24,
ASMi-30, ASMi-31, ASMi-32, etc. For such modules, the CM-2 module provides
the terminal interface.
Format
NODE nn DEF OPR
Procedure
➤ To define general and access parameters:
1. Type: NODE nn DEF OPR <Enter>.
nn stands for the module node number in the range of 1 through 12.
The first line of the module data entry form appears (see Figure D-17).
MODEM ADVANCED SETUP
MODEM NAME: ASMI-31CQ(m)
DEFINE MODEM PORT NUMBER : 1
DEFINE STATUS : MASTER PERMANENT
SELECT MODEM : MODEM 1 LOCAL
1) STOP STATUS UPDATE : DISABLE
2) CHANGE LOCAL MODEM STATUS : MASTER
3) MANAGEMENT FROM REMOTE MODEM : NO
4) MDOEM MANAGEMENT LINK : ENABLE
5) LOAD CONFIGURATION FROM : N/A MODEM
6) I-TYPE (Far End Modem type) : YES
7) MODEM RESET : NO
8) FACTORY RESET : NO
9) CARD RESET : NO
Figure D-17. Modem Advanced Setup Screen
Use the general procedures to define the parameter values, as required.
The contents of the form depend on the module type. Refer to the Installation and
Operation Manual of the corresponding module for detailed information. Note
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com