RAD Data comm LRS-24 - Manual (Page 106)

Appendix D CM-2 Management Commands LRS-24 Installation and Operation Manual
D-4 Defining LRS-24 And CM-2 SNMP Agent Parameters
Table D-1. DEF CALL Fields (Cont.)
Field Name Description Options
ALT NUM MODE Enables dialing the alternate number. NO – Dialing the alternate
number is disabled. CM-2
stops the call attempt after the
NUM OF RETRIES call
attempts on the primary
number have failed.
YES – Use of the alternate
number is enabled. The
alternate number is dialed
after the NUM OF RETRIES
call attempts on the primary
number have failed.
NA – Not available, same as
the value NO
ALT NUM Alternate phone number
Returning to Terminal Mode
➤ To return to the terminal mode while the Dial Modem Status is Active:
1. Disconnect the modem from the terminal port.
2. Wait for one minute.
The Dial Modem Status automatically becomes INACTIVE.
D.2 Defining LRS-24 And CM-2 SNMP Agent Parameters
Purpose
Defines or modifies the parameters of the CM-2 module (including the parameters
of the SNMP agent), and the general LRS-24 parameters. This command is always
addressed to the CM-2 module. Therefore the node address must always be 13.
The SNMP agent parameters must be defined before it is possible to manage the
LRS-24 using SNMP-based management stations. Refer to Appendix C for
additional information related to IP and SNMP parameters.
Format
NODE 13 DEF HUB
Procedure
➤ To define the LRS-24 and SNMP agent parameters:
1. Type: NODE 13 DEF HUB<Enter>.
The first line of the data entry form (name entry form) appears.
2. Enter name of hub. Press <Enter> to store the data.
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com