RAD Data comm LRS-24 - Manual (Page 141)

LRS-24 Installation and Operation Manual Appendix D CM-2 Management Commands
Displaying I/O Module Status D-39
D.17 Displaying I/O Module Status
Purpose
Displays complete status and diagnostic information for selected I/O module.
This command is relevant only for I/O modules that do not support direct
management by SNMP or by supervision terminal. For such modules, the CM-2
module provides the terminal interface.
Format
NODE nn DSP STT
Procedure
➤ To display the information:
• Type: DSP nn DSP STT <Enter>.
nn stands for the node number of the desired module, in the range of
1 through 12.
The status and diagnostic information data form for the specified module
appears.
The contents of the form depend on the module type. Refer to the Installation and
Operation Manual of the corresponding module for detailed information.
MODEM STATUS
MODEM NAME : ASMI-31CQ(m)
DEFINE MODEM PORT NUMBER : 1
SELECT MODEM : MODEM 1 LOCAL REMOTE MODEM : ASMI-31
INTERFACE MODULE : SCASI-68 & RJ11*4 REMOTE SLOT : N/A
MODEL PORT : RS-530 REMOTE MODEM LINE CONNECTOR: TERM. BLOCK
SW VERSION : 00.10 REMOTE MODEM FRONT PANEL : LCD
HW VERSION : 00.00 HW PANEL VERSION : 03
LED STATUS: 1) RTS OFF 2) DCD OFF 3) TEST OFF 4) ERR OFF
5) ELE-LOW ---- 6) ELE-AIS ---- 7)OPT-LOW ---- 8)OPT-AIS ----
LINK QUALITY : GOOD PS PHANTOM STATUS : N/A
BPV ERROR : 37 E+01 CHASSIS : N/A
FIBER OPTIC ERROR : 37 E+01 WAVE LENGTH : N/A
LINE UTILITY : 00 %
BERT RUN TIME : 0 BERT ERR SECONDS : 0
BERT SYNC LOSS : 0 BERT PRE FEC : 0
BERT POST FEC : 0
Figure D-42. Modem Status Screen
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com