Quick Eagle Networks DL3800E - Manual (Page 45)

Terminal Interface 4-5
4
A
LARMS AND
S
TATUS
The ALARMS AND STATUS MENU is a view-only screen that allows you
to review the current ALARMS AND STATUS items being reported by the
DL3800E. To access this screen, move the highlight bar in the INVERSE
MULTIPLEXER MAIN MENU to ALARMS AND STATUS and press
Enter
.
The ALARMS AND STATUS display ( Figure 4-2 ) will appear on the screen
describing the status of the common equipment and each of the E1 ports
(lines), plus the status of the DTE leads and the current rate of the DTE
port.
Figure 4-2 ALARMS AND STATUS MENU
Following are the Alarm and Status items (severity) that may appear. The
Common Equipment alarms and status will appear first, followed by the
Network and the DTE alarms and status.
Table 4-2 3800E Alarm Descriptions
ALARM DESCRIPTION
NETWORK
LOS Loss of Signal -- Net Port does not detect
any E1 pulses
LOF Loss of Frame - Net Port does not detect a
valid E1 framing format
Major 01/01/90 04:58:17 Unit: 0 NET : 2 (114)
Network 15 Minute UAS Major Threshold Exceeded
Major 01/01/90 04:58:17 Unit: 0 NET : 1 (114)
Network 15 Minute UAS Major Threshold Exceeded
Digital Link DL3800E SR 2.00.00 NODE 7: 01/01/90 05:55:07 MJ
SELECTED DEVICE ADDRESS: 7.00.000 NAME:
CURRENT ALARMS AND STATUS ITEMS Exit Repeat
Common equipment status: No Ext Clk, Primary Clk, No Net Sync
Network ports:
PORT 1: LOS, RED, Active, OOF MN, UAS 15 MIN MJ Relative delay of 0.000 ms
PORT 2: LOS, RED, Active, OOF MN, UAS 15 MIN MJ Relative delay of 0.000 ms
PORT 3: BPV MN, OOF MN, BPVS 15 MIN MN
PORT 4: BPV MN, OOF MN, BPVS 15 MIN MN
PORT 5: LOS, RED, UAS 15 MIN MJ
PORT 6: LOS, RED, UAS 15 MIN MJ
PORT 7: LOS, RED, UAS 15 MIN MJ
PORT 8: LOS, RED, UAS 15 MIN MJ
RS449/X.21 port: DSR ON
Current RS449/X.21 port rate = 3.952 Mbits/sec