Dte status, Net (1-8) status, Net (1-8) statistics – Quick Eagle Networks DL3800E User Manual
Page 97
Front Panel Interface
5-9
5
DTE Status
The next display shows the status of the DTE data port. The menu is
accessed by pressing Enter when
DTE STATUS
appears in the display.
If errors are detected, one or more of the following messages will appear.
Use the down and UP ARROW buttons to view further messages.
See
Table 4-2 on page 4-5
for a list of those Common Equipment Alarm and
Status items that could appear in this menu.
NET (1-8) Status
The next eight displays show the status of the E1 Networks (NET 1
STATUS through NET 8 STATUS if all are installed). Use the UP and
DOWN ARROW buttons to select the E1 Network to be monitored and
press Enter. Use the UP and DOWN ARROW buttons to view further
status items relating to the same E1 circuit.
See
Table 4-2 on page 4-5
for a list of those Common Equipment Alarm and
Status items that could appear.
NET (1-8) Statistics
The menu provides you with the various performance statistics of the
individual E1 circuits. These performance statistics are listed and defined
in
Table 5-3
. To view the statistics of a particular E1 circuit, press Enter
when the display reads
NET N.STATISTICS
, where N is the number of the
desired E1 network port.
The following table lists and explains the information that can be viewed
from the NET STATISTICS MENU, for each performance statistic:
Table 5-2 NET STATISTICS MENU Information Display
Front Panel Display
Explanation
NET N XXX
XXX = the performance statistic.
N = the E1 network port (1-8).
SEC YYY VALID. Z
YYY = the number of seconds into the current interval.
Z = the number of valid 15 minute intervals since the error counters were reset
(0-96).
CUR. X
X = the error count within a statistics period.
TOTL. X
X = the number of errors in the current interval.