Quick Eagle Networks DL3800E - Manual (Page 79)

Terminal Interface 4-39
4
SNMP Configuration
Through the SNMP CONFIGURATION MENU, you configure the
Network Manager (NMS) port on the rear panel of the DL3800E, setting
various addresses and configurable items required for operation with an
SNMP Network Manager. The DL3800E unit utilizes SLIP protocol over the
RS232 port to communicate with the SNMP management station.
To access the SNMP CONFIGURATION MENU, move the highlight bar to
SNMP CONFIGURATION in the CONFIGURATION MENU, and press
Enter
.
Figure 4-19 is an example of the SNMP CONFIGURATION MENU, and
Table 4-9 describes the SNMP parameters:
Figure 4-19 SNMP CONFIGURATION MENU
NOTE: If the you try to access a screen or perform a function beyond
your allowed access level, the following message appears:
Access
denied - your account does not have this PRIVILEGE
.
DIGITAL LINK DL3800E SR 3.01.0B NODE 1:123 08/27/00 00:55:51 MJ
SELECTED DEVICE ADDRESS: 1.00.000 NAME:123
SNMP CONFIGURATION Exit Confirm
NMS SERIAL PORT (SLIP)
UNIT IP ADDRESS: 172.019.001.038 UNIT IP SUBNET MASK:255.255.255.000
TRAP IP ADDRESS: 0.000.000.000 Port: Slip
0.000.000.000 Port: Slip
0.000.000.000 Port: Slip
REMOTE IP ADDRESS: 0.000.000.000
SLIP TRAP DELAY: 0seconds REMOTE TRAP DELAY: 0 seconds
READ COMMUNITY STRING: public
WRITE COMMUNITY STRING: public
TRAP COMMUNITY STRING public
SNMP BAUD RATE: 9600
SNMP #BITS AND PARITY: 8 bits, No parity
SNMP STOP BITS: 2 bits