Quick Eagle Networks DL3800E User Manual
Page 65
Terminal Interface
4-25
4
Network Configuration
This submenu allows you to configure various Network parameters. The
configurable parameters include CRC4, TSLOT16, and National Bits.
To access the NETWORK CONFIGURATION MENU, move the highlight
bar to NETWORK CONFIGURATION in the CONFIGURATION MENU
and press Return.
The NETWORK CONFIGURATION MENU will be slightly different
depending on which version DL3800E unit is being used.
Figure 4-13
shows the NETWORK CONFIGURATION MENU.
Table 4-7
describes the
various parameters included.
CA MODE
Allows user to set the CA lead to ASSERT, DEASSERT, or AUTOMATIC
when the interface is set to HSSI.
This setting is only accessible when the interface type is set to HSSI. To
change or set the CA lead status, use the UP and DOWN ARROW keys to
highlight CA and use space bar to toggle between ASSERT, DESSART, or
AUTOMATIC until the desired choice appears. Highlight CONFIRM and
press Enter to confirm the change. (In AUTOMATIC mode, the 3800
places the signal high when there is one or more active network signals.)
(Default - AUTOMATIC)
DTE LOSS DETECTION
Allows users to set the criteria by which a DTE Loss of Signal will be
detected when the interface is set to HSSI.
This setting is only accessible when the interface type is set to HSSI. To
change or set the DTE LOS criteria, use the UP and DOWN ARROW keys
to highlight DTE LOSS DETECTION and use the space bar to toggle
between TA and NONE until the desired choice appears. Highlight
CONFIRM and press Enter to confirm the change. (Default - TA)
Table 4-6 DTE CONFIGURATION MENU Options (Continued)
Parameter
Description/Action