Quick Eagle Networks DL3800E - Manual (Page 60)

4-20 DL3800E Inverse Multiplexer User’s Guide — July 9, 2001
4
To update the node database with all the changes made, move the
highlight bar to CONFIRM and press Enter. Changes can be confirmed
after each change, or, after all changes have been made. This completes the
node configuration. To abort the changes, move the highlight bar to EXIT
and press Enter before confirming the changes. (Note: If the terminal
speed, parity or stop bits are changed, it is necessary to change the
terminal before continuing.)
DTE Configuration
This menu allows you to configure certain parameters of the DTE,
including the interface type, clock source, status of leads, and loss criteria.
To access the DTE CONFIGURATION MENU, move the highlight bar to
DTE CONFIGURATION in the CONFIGURATION MENU, and press
Enter
.
Figure 4-9 , 4-10, 4-11, and 4-12 are examples of the DTE Configuration
Interface Menus (V.35, RS-449, X.21, and HSSI), and Table 4-6 describes the
menu items.
Terminal Multidrop Mode If the terminal is connected to more than one DL3800E, it must be in
Multidrop Mode. If it is connected to only one unit, this feature can be
disabled. When it is disabled, the system starts up directly, without you
having to log in. To change this configuration, move the highlight bar to
Terminal Multidrop Mode, and use the Space Bar to toggle between the
options Enabled, and Disabled. (Default - Enabled)
Table 4-5 Node Configuration Options
Option Action