Technics SX-PR54/M - Manual (Page 129)

Part XI MIDI
130
QQTG0701
MI
DI
Mode Setting
Initialize the settings for when the NX SOUND or GM LEVEL 2 mode is ON.
1. On the MIDI MENU display, select MODE
SETTING.
• The display looks similar to the following.
2. Select the mode.
• There are two modes for GM LEVEL 2 depending on the
parts to use.
• The confirmation display appears. Press the YES button
to execute the function, or press the NO button to cancel
the function.
Input/output Setting
Make the settings which determine how various performance data is treated during data transmission and
reception.
1. On the MIDI MENU display, select
INPUT/OUTPUT SETTING.
• The display looks similar to the following.
2. Use the ▲ and ▼ buttons to select the item.
RIGHT 1 INPUT
CONDUCTOR:
When data for the RIGHT 1 part is received,
the CONDUCTOR determines which part it
is used for.
DIRECT:
When data for the RIGHT 1 part is received,
it is treated as RIGHT 1 data, and perform-
ance data for all parts is received on their
respective basic channels.
AUTO PLAY CHORD INPUT
ON: Input data for the ACCOMP, BASS, APC
and CHORD parts is received.
OFF: Data for the above parts is not received.
• MIDI channels should be assigned to the above parts
before exchanging data.
VELOCITY INPUT
DIRECT:
The VELOCITY value of received NOTE
ON data is treated as is.
OFFSET:
The VELOCITY value of received NOTE
ON data is offset (
−50 to 50).
• Select VELOCITY OFFSET VALUE. Use the
∧
and
∨
buttons to change the value.
• All the values are offset from the current value by the
fixed amount.
• The upper (127) and lower (1) limits cannot be
exceeded.
FIX:
The VELOCITY value of all received NOTE
ON data is set to a fixed value. (1 to 127)
• Select VELOCITY FIXED VALUE. Use the
∧
and
∨
buttons to change the value.
TECHNI-CHORD OUTPUT
ON: Keyboard notes generated by the
TECHNI-CHORD function are also trans-
mitted.
OFF: Only key note data of the pressed keys
is transmitted.
TRANSPOSE OUTPUT
ON: The note data of the transposed notes is
transmitted.
OFF: The note data of the played keys is
transmitted.
DRUM PATTERN OUTPUT
ON: Data from the DRUMS part is transmitted.
OFF: Data from the DRUMS part is not trans-
mitted.
AUTO PLAY CHORD OUTPUT
ON: The data for the ACCOMP and BASS
parts is transmitted.
OFF: The data for the above parts is not trans-
mitted.
• MIDI channels should be assigned to the above parts
before exchanging data.
16_Part XI.fm 130 ページ ２００３年５月１６日 金曜日 午後１１時４０分