Technics SX-PR54/M - Manual (Page 93)

Part V Disk Drive
93
QQTG0701
Dis
k
Driv
e
Loading data
Recall (load) the data from the disk to this instrument’s memories.
• Note that the load procedure causes any data which is currently stored in the relevant memories to be erased.
LOAD
Load data that saved to a disk into this instru-
ment’s memory.
1. Insert the disk with the stored data into the
Disk Drive. Push it all the way in until you hear
a click.
2. On the DISK MENU display, select LOAD.
• The display looks similar to the following.
• If there are only SMF files on the disk, the display auto-
matically changes to the SMF LOAD display.
3. Use the buttons below the display to select the
song (Technics file) you wish to load.
• If there are SMF files on the disk and you wish to load an
SMF file, press the SMF button. (Refer to next page.)
4. Press the LOAD button.
• The LOAD operation begins.
• When the operation has been successfully completed,
“COMPLETED!” is shown on the display.
• If song data was loaded, you can press the
START/STOP button to begin playback when the
SEQUENCER PLAY display is active.
• You can load the type of data for which only one song
can be recorded in the SEQUENCER. (This type is avail-
able for disks used with older Technics models.) Note,
however, that in this case, the song is loaded into SONG
1, but the data in SONG memories 2 to 10 are erased.
• You can also access the LOAD display by pressing the
DISK button for a few seconds.
ⅢⅢⅢⅢ
LOAD OPTION
Specify the kind of data you wish to load from the
disk to your instrument.
1. Use the PAGE buttons to access the PAGE
2/3 LOAD OPTION display.
• The display looks similar to the following.
2. Use the buttons below the display to specify
the types of data you wish to load (YES/NO).
• - - - - - indicates that this type of data has not been saved.
• This setting is canceled when you quit the LOAD display
or when another file is selected.
3. Press the LOAD button.
• The LOAD operation begins.
ⅢⅢⅢⅢ
SINGLE LOAD
You can specify which data to load from a disk
into a specific PANEL MEMORY, COMPOSER
(MEMORY),
SOUND MEMORY, EFFECT
MEMORY or SEQUENCER (when SONG SAVE
was executed) memory.
1. Use the PAGE buttons to access the PAGE
3/3 SINGLE LOAD display.
• The display looks similar to the following.
2. Use the MODE button to select the data you
wish to load.
3. Use the BANK/SINGLE button to select the
load increment. (except for SEQUENCER)
BANK:
Load one bank at a time.
SINGLE:
Load the smallest data increment.
4. Follow the appropriate procedure to load the
specified data.
• Specify the data source for SONG (left side), and the
data destination (this instrument’s memory location) for
TO.
10_Part V.fm 93 ページ ２００３年５月１６日 金曜日 午後８時４１分