Technics SX-PR54/M - Manual (Page 84)

Part IV Composer
84
QQTG0701
C
o
m
p
o
ser
QUANTIZE:
Smooth out any unevenness in the timing of
your performance.
• Before recording, select the note value for the desired
quantize level. (The quantize level is shown on the dis-
play as QUANTIZE=.)
KEY IN CHORD MODIFY <PAGE 2/2> (except
for INTRO, ENDING, DRUMS):
Use the GROUP and TYPE
∧
and
∨
buttons
to select the type of pattern progression.
• This setting is for the sound that is going to be recorded
from this time.
5. Use the buttons below the display to switch to
a different recording part, and proceed to
record each part in turn.
6. When you have finished recording the rhythm,
turn off the PROGRAM MENUS button.
Chord Modify Change
For data that has already been recorded, you can select the type of pattern progression for the bass and
accomp parts.
• This function cannot be used for the INTRO and ENDING patterns.
1. On the RECORDING display, press the
CHORD MODIFY CHANGE button.
• The display looks similar to the following.
2. Use the PART
▲ and ▼ buttons to select the
part you wish to set.
3. Use the GROUP and MODIFY TYPE
∧
and
∨
buttons to select the corresponding progres-
sion type.
• If a progression type for which the note name is displayed
(in C key) was selected for the chord group, played notes
which are not displayed are changed to notes which are
displayed.
4. Use the FUNCTION
∧
and
∨
buttons to
enable or disable the function.
KEEP: No change.
CHANGE: The change is enabled.
5. When you have finished making the settings
for each part, press the OK button.
6. Press the EXIT button.
Part Setting
You can make detailed settings for each part.
1. On the REALTIME RECORDING display,
press the PART SETTING button.
• The settings comprise 3 pages of the display. Use the
PAGE buttons to switch pages.
2. Use the PART ▲ and ▼ buttons to select a
part.
3. Use the
∧
and
∨
buttons to set the corre-
sponding item.
<PAGE 1>
09_Part IV.fm 84 ページ ２００３年５月２０日 火曜日 午後５時２５分