Technics SX-PR54/M - Manual (Page 76)

Part III Sequencer
76
QQTG0701
Se
qu
en
cer
• The track assignment settings are also copied. Note that
in some cases, the CONTROL, RHYTHM and CHORD
part data in the destination tracks may be lost.
TRACK MERGE
Merge the recorded contents of two tracks
(source tracks) and store the merged contents in
a third track (destination track).
• When the TRACK MERGE function is executed, the data
is erased from the two source tracks.
1. Select the two source tracks (FROM).
• On the FROM side, use the TRACK
∧
and
∨
buttons to
select the two source tracks.
• You cannot select the track to which the CONTROL,
RHYTHM or CHORD part has been assigned.
• If the part assigned to the left source track (“left” meaning
its position on the TRACK MERGE display) is different
from the part assigned to the right source track, when the
parts are merged in the destination track, the new track is
assigned the same part as the left track.
2. Select the destination track (TO).
• Use the TRACK
∧
and
∨
buttons to the right of the dis-
play to specify the track number.
3. Press the OK button.
• The confirmation display appears. Press the YES button
to execute the function, or press the NO button to cancel
the function.
MEASURE COPY
Copy recorded data of specified measures to a
specified point.
• On the destination track, the new data replaces the cur-
rent measure contents.
1. Specify the measures you wish to copy from
the source track (FROM).
• On the FROM side, specify the settings with the corre-
sponding buttons.
TRACK:
Specify the track number you wish to copy
the measures from.
• You cannot select the track for the RHYTHM part or
CHORD part in which a repeat command has been
stored.
• If ALL is selected, the specified measures are copied
to all tracks at the same time.
FIRST MEAS:
Specify the first measure to copy.
LAST MEAS:
Specify the last measure to copy.
2. Specify where you wish to copy the selected
measures to.
• On the TO side, specify the settings with the correspond-
ing buttons.
TRACK:
Specify the track number you wish to copy
to.
• Measures in a track for the CONTROL, RHYTHM or
CHORD part can be copied only to the same track.
START MEAS:
Specify the start point to copy the selected
measures to.
REPEAT:
Specify the number of times the selected
measures are to be repeated.
3. Press the OK button.
• The confirmation display appears. Press the YES button
to execute the function, or press the NO button to cancel
the function.
• Note that if the END command is included in the source
data, it is also copied. Any data following the END com-
mand is not copied.
MEASURE ERASE
Erase the recorded contents of specific mea-
sures. You can also specify which type of data is
to be erased.
• Note that only the contents of the measures are erased,
not the measures themselves; the length of the perfor-
mance remains the same.
1. Use the TRACK
∧
and
∨
buttons to specify
the track number.
• This function does not work for the RHYTHM part or
CHORD part in which a repeat command has been
stored.
• If ALL is selected, data is erased from the specified mea-
sures of all the tracks at one time.
2. Use the FIRST MEAS
∧
and
∨
buttons to
specify the start point (measure number).
3. Use the LAST MEAS
∧
and
∨
buttons to spec-
ify the end point (measure number).
08_Part III.fm 76 ページ ２００３年５月１６日 金曜日 午後５時４１分