Technics SX-PR54/M - Manual (Page 65)

Part III Sequencer
65
QQTG0701
Se
qu
en
cer
7. Press the REC STOP button at the point you
want to stop recording.
• Punch recording stops immediately.
• You can also begin punch-in recording by playing the
keyboard.
• You can specify the punch-in/punch-out points with the
Pedal. (Refer to page 120.)
ⅢⅢⅢⅢ
AUTO PUNCH RECORD
You can also set the punch-in and punch-out
points beforehand, so that recording automati-
cally begins and ends at the specified points.
1. On the PUNCH RECORD display, press the
AUTO: OFF button.
• The display looks similar to the following.
2. Use the FIRST MEASURE
∧
and
∨
buttons to
specify the number of the punch-in measure.
3. Use the LAST MEASURE
∧
and
∨
buttons to
specify the number of the punch-out measure.
• The number of the LAST measure must be higher than
the number of the FIRST measure.
• The specified measure is recorded.
4. Use the COUNT IN MEASURE
∧
and
∨
but-
tons to specify the number of lead-in mea-
sures you wish to have played back before the
punch-in measure.
• Set the metronome to on or off with the ON or OFF but-
ton.
5. Press the EXIT button.
• The display changes to the PUNCH RECORD display.
6. Press the START/STOP button.
• Playback begins from the measure indicated by MEA-
SURE on the display.
• Pertinent information, such as the FIRST MEASURE, is
shown in the upper section of the display.
7. Correct the performance.
• The mode changes automatically to the recording mode
at the specified FIRST measure. Begin playing at this
point. The mode automatically changes back to the play-
back mode at the specified LAST measure.
• To discontinue punch recording in the middle, press the
CANCEL button. In this case, the recorded contents up to
that point are erased.
Step Record
STEP RECORD is simply a method of making a tune by storing the sounds note-by-note on the display.
Instead of playing the keyboard directly as in the REALTIME RECORD mode, you can take your time to
input each single note. This is an especially effective method for storing complicated passages that are
difficult to play or when the exact timing of a part is critical.
Recording procedure
Record the keyboard performance and panel
changes.
1. On the SEQ MENU display, use the SONG
SELECT
∧
and
∨
buttons to select the song
number. Then select RECORD & EDIT.
2. On the RECORD & EDIT display, select STEP
RECORD.
• The display changes to the PART SELECT display.
3. Use the balance buttons below the display to
specify the track for the part you are going to
record (only one track can be selected at a
time).
(Continued on the next page)
08_Part III.fm 65 ページ ２００３年５月１６日 金曜日 午後５時４１分