Technics SX-PR54/M - Manual (Page 77)

Part III Sequencer
77
QQTG0701
Se
qu
en
cer
4. Use the ERASE DATA
∧
and
∨
buttons to
specify the type of data to be erased.
ALL:
All data is erased.
NOTE:
Only note data is erased.
CONTROL:
Only control data (volume, effect and other
panel settings as well as selection changes)
is erased.
5. Press the OK button.
• The confirmation display appears. Press the YES button
to execute the function, or press the NO button to cancel
the function.
MEASURE DELETE
Delete specified measures from a track.
• The length of the performance accordingly decreases by
the number of deleted measures.
1. Use the TRACK
∧
and
∨
buttons to select the
track from which measures are to be deleted.
• This function does not work for the CHORD or RHYTHM
track in which the repeat function has been stored.
• If ALL is selected, the specified measures are deleted
from all the tracks at one time.
2. Use the FIRST MEAS
∧
and
∨
buttons, to
specify the first measure to delete.
3. Use the LAST MEAS
∧
and
∨
buttons to
specify the last measure to delete.
4. Press the OK button.
• The confirmation display appears. Press the YES button
to execute the function, or press the NO button to cancel
the function.
MEASURE INSERT
Insert specified measures at a specified point.
• The length of the performance accordingly increases by
the number of inserted measures.
1. Specify the measures you wish to copy from
the source track.
• On the FROM side, specify the settings with the corre-
sponding buttons.
TRACK:
Specify the track number you wish to copy
the measures from.
• This function does not work for the CHORD or
RHYTHM track in which the repeat function has been
stored.
• If ALL is selected, the measures are inserted in all
tracks at the same time.
FIRST MEASURE:
Specify the first measure to copy.
LAST MEASURE:
Specify the last measure to copy.
2. Specify where you wish to insert the selected
measures.
• On the TO side, specify the settings with the correspond-
ing buttons.
TRACK:
Specify the track number.
• Measures from the CHORD, RHYTHM or CONTROL
track can only be inserted in the same track.
START MEASURE:
Specify the start point to insert the selected
measures.
REPEAT:
Specify the number of times the selected
measures are to be repeated.
3. Press the OK button.
• The confirmation display appears. Press the YES button
to execute the function, or press the NO button to cancel
the function.
• Note that if the END command is included in the source
data, it is also inserted. Any data following the END com-
mand is not inserted.
08_Part III.fm 77 ページ ２００３年５月１６日 金曜日 午後５時４１分