Technics SX-PR54/M - Manual (Page 89)

Part IV Composer
89
QQTG0701
C
o
m
p
o
ser
ⅢⅢⅢⅢ
Copying individual parts
1. Use the PAGE
∧
and
∨
buttons to select
PAGE 2/2.
• The display looks similar to the following.
2. On the FROM side, use the buttons to specify
the part to copy from.
• For the DRUM part you can specify the DRUMS 1 or 2
part; for other parts you can specify a part other than a
DRUMS part.
3. Specify the destination on the TO side to
which the part will be copied.
4. Press the OK button.
SEQ TO COMPOSER COPY
Data from the SEQUENCER can be copied to a
COMPOSER memory. For example, you can
use a rhythm pattern on a song disk as the auto-
matic accompaniment for your own performance.
1. Play back the song you wish to copy from
SEQUENCER to confirm the tracks, the mea-
sures and the time signature you wish to copy.
2. Follow the procedure in “Prepare to record” to
prepare the COMPOSER memory you will be
copying to. (Refer to page 82.)
• Be sure that time signature setting in the SEQUENCER
data you are copying from and the time signature in the
COMPOSER memory you are copying to are the same,
or the data will not be copied successfully.
3. On the COMPOSER MENU display, select
SEQ TO COMPOSER COPY.
• The display looks similar to the following.
4. Use the FIRST MEAS
∧
and
∨
buttons to
specify the number of the first measure to
copy.
5. Use the LAST MEAS
∧
and
∨
buttons to spec-
ify the number of the last measure to copy.
6. Use the TRANSPOSE
∧
and
∨
buttons to
change the key of the copied measures ( −24
to +24).
• Units are in semitones.
7. Use the MEMORY
∧
and
∨
buttons to specify
the COMPOSER memory to copy to.
8. Use the PATTERN
∧
and
∨
buttons to specify
the pattern to copy to.
9. For each COMPOSER part, specify the
SEQUENCER track from which to copy data.
• Use the PART ▲ and ▼ buttons to specify the part name,
and the TRACK
∧
and
∨
buttons to specify the track
number.
• Parts which are set to OFF are blank.
10. Press the OK button.
• “COMPLETED!” is shown on the display.
• If you wish to use the COMPOSER function to edit the
copied data, press the EDIT button, and follow the proce-
dure to record a pattern.
• In the case of INTRO or ENDING, if a measure contains
a Maj or Min command, it is reproduced in the other pat-
tern as well.
09_Part IV.fm 89 ページ ２００３年５月２０日 火曜日 午後５時２５分