Toshiba Strata DK 16 - Manual (Page 109)

PROGRAMMING PROCEDURES-INSTRUCTIONS/SYSTEM RECORDS
SECTION 100-816-302
MARCH 1993
2-85
PROGRAM 60
SMDR OUTPUT/ACCOUNT CODE DIGIT LENGTH
6 0 P S H H Z Z S
For “2” SMDR Threshold Time = 0 or 1
SELECT = 2 ~ 6 (Item)
Make a selection to indicate
which item is being assigned.
Select 2 for SMDR Threshold
Time.
Select 3 for SMDR output, etc.
For “4” ACCOUNT = 04 ~ 15
3
Item Description Data
SMDR Output when a call is completed.
0 = Outgoing Only 1 = Incoming and Outgoing
= 0 All Calls
= 1 Dial “0” calls only
= 2 Dial “1” calls only
= 3 Dial “00” calls only
= 4 Dial “1”, “0”, calls only
= 5 Dial “1” or “00” calls only
DISA Security Code (may be changed
from station, per
) Program 30
(SMDR COR)
(ACCOUNT)
(TOLL DIAL DATA)
DATA
5
6
For “5” TOLL DIAL, 0 ~ 5
For “6” DATA = DISA security code; 1 ~ 15 digits
For "7" CREDIT = Credit Card Digits; 1 ~ 30 digits
9
Printout options
Toll Dial
Credit card call digit length, 01 ~ 30 digits,
(see Program 43)
CREDIT
7
11
4
Forced/Voluntary Account Code Digit
Length 04 ~ 15.
(Digits are verified per Prog. 30, LED 14, and
Prog. 69. See Note 4)
10
~
For “3” SMDR COR = 0 or 1 (Data)
2
SMDR Threshold Time
0 = 1.0 seconds 1 = 10 seconds
TIME
12
7
NOTES:
1. For more information, see the instructions preceding the record sheets.
2. For Selection 3, initialized data assigns SMDR output to be enabled for incoming calls that are answered.
3. For selection 4, initialized data assigns a 6-digit length to all Forced/Voluntary Account Codes.
4. If PBX code is dialed, numbers dialed after the code will be checked.
5. If A/C, O/C or SPCC code begins with "0", "1", or "00", that call will print out.
6. When accessing LCR feature, all digits sent to CO will be output.
7. Programming 60-3-0 (printout outgoing calls only) is still available.
8. Button/LED 1 = blank, Button/LED 2 = don't care.
9. If a security code is not programmed, outgoing CO line access via DISA will not require a security code when dialing.
10. See Program 69 for Verified Account Codes.
11. Number of digits required when "0" is the first digit dialed; if this number of digits is not dialed, the system will disconnect
the call after 20 seconds. "0" is counted as a digit. Example: 0 + 1 + 714 + 583 - 3700 = 12 digits; 12 should be
programmed as a minimum in this case.
12. Default is 10 seconds.