Toshiba Strata DK 16 - Manual (Page 7)

PROGRAMMING PROCEDURES-INTRODUCTION
SECTION 100-816-301
MARCH 1993
1-3
TABLE 1-A
SIMPLE PROGRAM: PROGRAM 33
(STATION HUNTING)
Step
#
Press...
BUTTONS + LED keys
Action description LCD RESPONSE ...
1. Use an LCD digital or electronic telephone.
Make sure the programming button strip template is
installed on the programming telephone (see
Paragraph 3.24).
JAN 20 SUN
NO. OF STATION (10 ~ 29)
06:43
2.
Enter programming mode. PROGRAM MODE
* # * # 1 * 2 * 3
3.
Access Program 33. System beeps after key
is pressed to indicate program number may be entered. PROGRAM = 33
DATA STORE
SPKR 3 3 HOLD
SPKR
4.
Prepare the system for a station port selection. 33 SELECT =
SPKR
5.
Select the logical port number of the “Hunt From” station.
Up to two digits followed by the
# key, or a range of ports
can be entered as specified on the record sheet.
33 SELECT = (00 ~ 19)
HUNT TO =
0 0 ~ 1 9 (0 0 ~ 0 9 for DK8)
6.
Enter the logical port number of the “Hunt To” point, as
recorded on the system record sheet. Press LED key 01
to delete a digit from Hunt To point ports. 33 SELECT = (00 ~ 19)
HUNT TO = (00 ~ 19)
0 0 ~ 1 9 (0 0 ~ 0 9 for DK8)
7.
Secure data in system programming.
33 SELECT = (00 ~ 19)
DATA PROGRAMMED
HOLD
8.
Prepare system for another selection (go back to
step 5), or exit Program 33 (continue with step 9).
33 SELECT = SPKR
9.
Secure Program 33 data in system memory.
33 SELECT = ##
DATA PROGRAMMED
# # HOLD
10.
Exit Program 33. Enter another program number or
exit programming mode (go to step 11).
Speaker beeps to indicate it is exiting Program 33.
PROGRAM = SPKR
11.
Exit programming mode.
# # HOLD
NO. OF STATION (10 ~ 29)
JAN 20 SUN
06:58