Toshiba Strata DK 16 - Manual (Page 76)

PROGRAMMING PROCEDURES-INSTRUCTIONS/SYSTEM RECORDS
SECTION 100-816-302
MARCH 1993
2-52
NOTES:
1. For more information, see the instructions preceding the record sheets.
2. Initialized data lights LEDs 07, 08, 09, 18, 19, and 20.
3. LED 04 DTMF Signal Time applies to manual and Speed Dial tones sent out of the system via CO lines. LED 04 does not apply
to Call Forward or voice mail ID DTMF tones sent to voice mail ports. (See Program 10-2, LED 06, for tones sent to voice mail
ports.)
4. If Ring Transfer is allowed, set Ring Transfer Recall time in Program 37; if ring transfer is not allowed (LED 07 off), the station
will recall immediately if transfer is attempted.
5. Standard ring pattern is 1 sec. on, 3 sec. off.
6. Two CO conference must be allowed for DISA operation.
7. CO line guard time is the time interval the system requires to release a CO line and allows it to be re-seized. If LED 02 is off,
all lines are set with 0.45 second guard time; if LED is on, guard time is 0.45 or 1.5 seconds per Program 42-0.
8. This option selects CO line dial pulse rate for DK8 only, see Program 15-2 to select DK16 dial pulse rate.
PROGRAM 10-1
SYSTEM ASSIGNMENTS, PART 1 OF 3
20
19
18
17
16
15
14 8
13
12
11
10
09
08
07 4
06 5
05
04 3
03
02 7
01
H Z Z 1 P S H S 0
Button/LED X LED On LED Off
Two CO Conference/Allowed 6
Conference/Allowed
Ring Detect Time - Normal
Intercom Volume PAD (-8 dB)
–
–
CO Line Dial Pulse Rate; 20PPS
–
ABR Cycles/10 times
ABR Redial time/30 sec.
System Speed Dial Override Toll Restriction
Exclusive Hold/Allowed
Alternate Point Answer
Ring Transfer of CO Lines Allowed
CO Repeat Ringing
Incoming Call Abandon/8 sec.
CO DTMF Signal Time/160 msec.
DP Make Ratio/33%
0.45 or 1.5 sec. per Program 42-0
Tone First (from DKTs/EKTs)
Not Allowed
Not Allowed
Ring Detect Time – Short Rings
No Intercom PAD
–
–
CO Line Dial Pulse Rate; 10PPS
–
15 times
1 min.
Restricted
Not Allowed
Transfer Privacy
Not Allowed
Standard Ring
6 sec.
80 msec. 3
40%
CO line re-seize guard time 0.45
Voice First (from DKTs/EKTs)
SELECT = 1
Light LEDs as described
in the table below
1
Button/LEDs
2
2
2
2
2
2