Toshiba Strata DK 16 - Manual (Page 8)

PROGRAMMING PROCEDURES-INTRODUCTION
SECTION 100-816-301
MARCH 1993
1-4
NO.OF STATION (10 ~ 29)
06:43
TABLE 1-B
MULTIDIMENSIONAL PROGRAM: PROGRAM 30
(STATION CLASS OF SERVICE)
Step
#
Press...
BUTTONS + LED keys
Action description LCD RESPONSE ...
1. Use an LCD electronic or digital telephone.
Make sure the programming button strip template is
installed on the programming telephone (see
Paragraph 3.24).
JAN 20 SUN
* # * # 1 * 2 * 3
Enter programming mode.
2. PROGRAM MODE
SPKR 3 0 HOLD
Access Program 30. System beeps after
button is pressed to indicate a program number may
be entered.
3. PROGRAM = 30
SPKR DATA STORE
SPKR
Prepare system for a port number selection.
4. 30 SELECT =
5. 0 0 ~
Enter the logical port number where the station being
defined is connected. Use two digits, followed by a
#
key. A range of ports can be entered as specified in the
record sheet.
30 SELECT = (00 ~ 19) 1 9 (0 0 ~ 0 9 for DK8)
6. LED keys 01 ~ 20
LED keys 01 ~ 20 activate features for each station port
or port range. Make the following selections by turning
the appropriate led key ON or OFF for each item (01 ~
20) for each port, as marked on the system record
sheet:
LED 01 ON: Speakerphone Enabled
LED 02 ON: Microphone Key Lock Enabled
LED 03 ON: Microphone ON at Start of Call
LED 04 ON: Not Used
LED 05 ON: Speed Dial Allowed
LED 06 ON: Automatic Busy Redial Access Enabled
LED 07 ON: OCA/Busy Override Automatic
LED 08 ON: Forced Account Code Enabled
LED 09 ON: Toll Restriction Override Code Revision
Authority
LED 10 ON: DISA Security Code Change Allowed
LED 11 ON: Dial Pulse (DTMF Off) for Standard
Telephone