Toshiba Strata DK 16 - Manual (Page 95)

PROGRAMMING PROCEDURES-INSTRUCTIONS/SYSTEM RECORDS
SECTION 100-816-302
MARCH 1993
2-71
NOTES:
1. For more information, see the instructions preceding the record sheets.
2. Initialized data reads Buttons/LEDs 01, 02, 04, and 05 lit for ports.
3. Enter a range of ports by keying in the following sequence:
4. Button/LEDs 01, 02, and 04 should be lit for all stations connected to voice mail (VM) ports to allow proper VM
integration. Button/LEDs 01 and 02 should be lit for all stations (even non-LCD), unless it is desired to disable the LCD
and message waiting indication.
5. This feature applies to calling ports (typically VM/auto attendant ports) that transfer CO line calls (can be telephone
stations, too).
6. This feature applies to called ports (stations) that must receive calls from VM/auto attendant ports (can be telephone
stations, too) when busy.
7. Does not apply to Off-hook Call Announce calls; OCA calls will forward after 12 seconds (CFNA time out) if not
answered.
8. May be required for dialing with Personal Computers connected to 2000-series digital telephone (PDIU-DI2) data
interface units.
PROGRAM 35
STATION CLASS OF SERVICE
Low port High port
3 5 P S H H Z Z
Button/LEDs
Feature LED
Logical Port Numbers
00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19
SELECT = Logical Port Number (00~19)
S
Enter the port number(s) being
defined. See Note 3 for
entering a range of ports.
NOTE: Shaded areas apply to DK16 only
Select LEDs to light for the port specified
in the last step. All LEDs marked with
an “X” in the table below should be lit.
Busy Station Transfer 5
Busy Station Ring 6
Automatic Hold
Disable continuous DTMF
tones on DKT 2000
8
No CF/NA on Handsfree 7
LCD Indiv. Message
Message Waiting (RCV)
LCD Type/32-ON/12-OFF 4
LCD Display 4
20
19
18
17
16
15
14
13
12
11
10
09
08
07
06
05
04
03
02
01