Toshiba RAS-09LKV-UL - Manual (Page 96)

– 96 –
No. Part name
Horizontal louver
Procedures
1) Remove shaft of the horizontal
louver from the back body.
(First remove the left shaft, and
then remove other shafts while
sliding the horizontal louver
leftward.)
Evaporator
(Heat exchanger)
1) Follow to the procedure in the item ƒ .
2) Remove the pipe holder from the rear side of the main unit.
3) Remove two fixing screws at the left side of the end plate of the heat exchanger.
Remarks
4) Remove one fixing screw on the
heat exchage fixing holder to separate the
heat exchage from the back body.
2 screws
Heat exchanger fixing
holder
Screw
„
l
FILE NO. SVM-10019
5) Remove one screw at below right side of
heat exchanger that used for fixing between
heat exchanger and back body by Fix
Evaporator (DN)
The Fix Evaporator (DN) is used for
transportation only and can be removed
without any concern to unit operation.
Follow to 7) for removing.
6) Remove right side of the end plate from
two fixing rib while sliding slightly the
heat exchanger rightward.
Rib on the right side of the end plate
Fix Evaporator (DN)
Screw
Fix Evaporator (DN)