Vidikron VP-60 - Manual (Page 12)

11
HOW TO ATTACH OPTIONS TO THE PLASMA MONITOR
You can attach your optional mounts or stand to the
plasma monitor in one of the following two ways:
1) While it is upright. (See drawing A)
2) As it is laid down with the screen face down (See
drawing B). Lay the protective sheet, which was
wrapped around the plasma monitor when it was
packaged, beneath the screen surface so it does not
scratch the screen face.
* DO NOT touch or hold the screen face when
carrying the unit.
• This device cannot be installed on its own. Be sure
to use a stand or original mounting unit. (wallmount
unit, stand, etc.)
• For correct installation and mounting, it is required
to use a trained, Vidikron Authorized Dealer. Failure
to follow correct mounting procedures could result
in damage to the equipment or injury to the installer.
Product warranty does not cover damage caused by
improper installation.
Use only the mounting kit or stand provided
by Vidikron. Refer to mounting kit for detailed
instructions.
50 mm (2")
50
mm
(2")
50
mm
(2")
Wall
Wall
50 mm (2")
50 mm (2")
Ventilation Requirements for enclosure mounting
To allow heat to disperse, leave space between surrounding
objects as shown on the diagram to the right when installing.
A
B