Vidikron VP-60 - Manual (Page 59)

2. Use the and buttons to select “SIDEBAR LEV.”.
3. To adjust the “SIDEBAR LEV.” ...
Use the and buttons to adjust the SIDEBAR LEV..
Setting the screen size for S1/S2 video input
If the S-Video signal contains screen size information, the image
will be automatically adjusted to fit the screen when this S1/S2 is
set to AUTO.
This feature is available only when an S-Video signal is input via
the VIDEO3 terminal.
Example: Setting the “S1/S2” to “AUTO”
Perform the following operations.
1. On the MAIN MENU, select “SETTING 2”, then press MENU
button. The “SETTING 2” screen appears.
2. Use the and buttons to select “S1/S2”.
3. Use the and buttons to select “AUTO”. The mode
switches as follows each time the and buttons is pressed:
OFF
AUTO
Information
■ SIDEBAR LEV. settings
This adjusts the brightness of the black (the Sidebar Lev.) for the
sides of the screen. The standard is 0 (black). The level can be
adjusted from 0 to 15. The factory setting is 3 (dark gray).
■ Restoring the factory default settings
Select “FACTORY” under the SETTING 1 menu.
Note that this also restores other settings to the factory defaults.
OSD (On Screen Display) Controls
AUTO OFF : OFF
CINEMA MODE : ON
PIXL PROTECT : OFF
SIDEBAR LEV. : 5
S1 / S2 : OFF
DVI TYPE
SETTING 2 2 / 3
SEL. ADJ. EXIT EXIT
PREVIOUS PG.
NEXT PAGE
PWR. MGT. : OFF
CINEMA MODE : ON
PIXL PROTECT : OFF
SIDE BARS
: 5
S1 / S2 : AUTO
AUTO SIZE : ON
DVI TYPE
SETTING 2 2 / 3
SEL. ADJ. EXIT EXIT
PREVIOUS PG.
NEXT PAGE
58