Vidikron VP-60 - Manual (Page 60)

4. Once the setting is completed...
Press the EXIT button to return to the SETTING 3 screen.
To return to the main menu, press the EXIT button once more.
Setting the signal and black level for DVI signal
Example: Setting the “PLUG/PLAY” mode on “STB/DVD”
Perform the following operations.
1. On the MAIN MENU, select “SETTING 2” , then press the
MENU button. The “SETTING 2” screen appears.
2. Use the and buttons to select “DVI TYPE”, then press the
MENU button. The “DVI TYPE” screen apprears.
3.To set PLUG/PLAY mode to “STB/DVD” ...
Use the and buttons to select “STB/DVD”.
The mode switches as follows each time the and buttons is
pressed:
PLUG/PLAY:
PC STB/DVD
BLACK LEVEL: LOW HIGH
OSD (On Screen Display) Controls
59
Information
■ S1/S2 Settings
AUTO........ Adjusts the screen size automatically according to
the S1/S2 video signal.
OFF............ Turns the S1/S2 funtion off.
■ Restoring the factory default settings
Select “FACTORY” under the SETTING 1 menu. Note that this
also restores other settings to the factory defaults.
PLUG/PLAY : STB/DVD
BLACK LEVEL : HIGH
DVI TYPE
SEL. ADJ. EXIT EXIT
Information
■ PLUG/PLAY Settings
PC............... When connected to the PC signal.
BLACK LEVEL is set to “HIGH” automatically.
STB/DVD.... When connected to a satellite receiver, DVD, etc.
BLACK LEVEL is set to “HIGH” automatically.
■ BLACK LEVEL settings
LOW ........ When connected to the PC signal.
HIGH ....... When connected to the satellite receiver, DVD, etc.
Change “HIGH” into “OFF” if the black level
apprears gray.