Vidikron VP-60 - Manual (Page 46)

45
OSD (On Screen Display) Controls
Setting the BNC connectors
Select whether to set the input of the 5 BNC connectors to RGB
and Component.
Example: Set the BNC INPUT mode to “COMP”
Press the MENU button on the remote control to display the
MAIN MENU on the screen, then...
1. Use the and buttons to select “SETTING 1”, then press the
MENU button. The “SETTING 1” menu appears.
2. Use the and buttons to select “BNC INPUT”.
3. To set the BNC INPUT mode to “COMP”...
Use the and buttons to select “COMP”. The mode switches as
follows each time the or button is pressed:
RGB ↔ COMP
4. Once the setting is completed...
Press the EXIT button to return to the main menu.
To delete the main menu, press the EXIT button once more.
■ OSD ORBITER settings
ON.......... The position of the menu will be shifted
by eight dots each time OSD is displayed.
OFF ........ OSD will be displayed at the same position.
■ Restoring the factory defaults settings
Select “FACTORY” under the SETTING 1 menu. Note that this
also restores other settings to the factory defaults for Auto Picture.
AUTO OFF : OFF f
CINEMA MODE : ON
PIXL PROTECT : OFF
GRAY LEVEL
: 3
S1 / S2 : OFF
DVI TYPE
SETTING 2 2 / 3
SEL. ADJ. EXIT EXIT
PREVIOUS PG.
NEXT PAGE
Information
■ BNC INPUT settings
RGB ......... Use the 5BNC terminals for RGB input.
COMP ...... Use the 3BNC terminals for Component input.
■ Restoring the factory default settings
Select “FACTORY” under the SETTING 1 menu.
Note that this also restores other settings to the factory defaults.