Vidikron VP-60 - Manual (Page 70)

DIVIDER
Set the 2x2 or 3x3 video wall.
Example: Setting “4”
Perform Steps 1-2 of VIDEO WALL, then...
3. Use the and buttons to select “DIVIDER”.
4. Use the and buttons to select “4”.
The mode switches as follows each time the or button is
pressed:
OFF 1 4 9
VIDEO WALL POSITION
Set the position of each display.
Example: Setting “4”
Perform Steps 1-2 of VIDEO WALL, then...
3. Use the and buttons to select “POSITION”, then press the
MENU button. The “VIDEO WALL POSITION” screen appears.
4. Use the and buttons to select “NO. 4”.
The mode switches as follows each time the or button is
pressed:
• 4 Screens
NO. 1 NO. 2 NO. 3 NO. 4
• 9 Screens
NO. 7 NO. 8 ....... NO. 14 NO. 15
69
OSD (On Screen Display) Controls
Information
■ Restoring the factory default settings
Select “FACTORY” under the SETTING 1 menu.
Note that this also restores other settings to the factory defaults.
DIVIDER : 4
POSITON
DISP. MODE : SPLIT
AUTO ID : OFF
IMAGE ADJUST
P. ON DELAY
: OFF
LUM SET LINK : OFF
REPTR TIME
: OFF
VIDEO WALL
SEL. ADJ. EXIT EXIT
Information
■ DIVIDER settings
OFF, 1 ......... 1 Screen (Matrix display function does not work)
4 .................. 4 Screens (2x2 video wall)
9 .................. 9 Screens (3x3 video wall)
* When you select “4” or “9”, set the VIDEO WALL POSITION.