Xantrex Technology RS3000 - Manual (Page 10)

Safety
viii 975-0170-01-01
5. Do not operate the Inverter/Charger if it has received a sharp blow,
been dropped, or otherwise damaged in any way. If the unit is
damaged, see the “Warranty and Return Information” section in the
RS3000 Sine Wave Inverter/Charger Operation Guide.
6. Do not disassemble the Inverter/Charger; it does not contain user
serviceable parts. Take it to a qualified service person when service or
repair is required. Incorrect reassembly may result in a risk of
electrical shock or fire. Internal capacitors remain charged after all
power is disconnected. For instructions on obtaining service, see the
“Warranty and Return Information” section in the RS3000 Sine Wave
Inverter/Charger Operation Guide.
7. Do not expose the Inverter/Charger to rain, snow, or water.
8. To reduce risk of electric shock, disconnect all sources of AC and DC
power from the Inverter/Charger before attempting any maintenance
or cleaning. Turning off controls will not reduce this risk.
9. The Inverter/Charger must be provided with equipment grounding
conductors connected to the AC input ground and chassis ground
terminals.
To reduce the risk of overheating, keep the ventilation openings clear and
do not install the Inverter/Charger in a compartment with limited airflow
or inadequate clearances around the unit. Refer to the
RS3000 Sine Wave
Inverter/Charger Installation Guide for required clearance.
CAUTION
Cautions identify conditions or practices that could result in damage to the unit or
other equipment.