Xantrex Technology RS3000 - Manual (Page 26)

Introduction
1–8 975-0170-01-01
Figure 1-3 Front Panel Lights and Buttons
Table 1-2 Description of Front Panel Lights and Buttons
Feature Description
1 External AC light illuminates when you are connected to an AC source like the utility grid or
a generator and the AC is qualified.
2 Inverter ON light illuminates when the RS3000 is operating in invert mode.
3 Low Battery light illuminates when the battery voltage is low.
4 Network light illuminates when there is activity on the network.
5 Fault light illuminates if a fault condition occurs.
6 Charger ON light illuminates when the RS3000 is in charge mode and is producing DC output
to charge your batteries.
7 Bulk light illuminates when the charger is in the bulk stage of battery charging.
8 Absorption light illuminates when the charger is in the absorption stage of battery charging.
9 Float light illuminates when the charger is in the float stage of battery charging.
10 Equalize light illuminates when the unit is equalizing the batteries.
11 Charger Enable button toggles between enable (On) and disable (Off). The Charge Enable
button illuminates when the charger is enabled and it can produce DC output to charge your
batteries. When the charger is disabled, it does not produce DC output to charge your batteries,
but still passes AC input through to AC loads (if present).
12 Inverter Enable button toggles between enable (On) and disable (Off). The Inverter Enable
button illuminates when the inverter is enabled and it can produce AC output to run your AC
loads. When the inverter is disabled, it does not produce AC output to run your loads.
13 Reset button is used for several functions: to reset after a fault, to perform a power on reset, to
wake the RS3000 from Power Save mode or Hibernate mode. See “Operating in Invert Mode”
on page 2–6 for a description of the different modes.
2
3
4
5
6
7
9 10 13
11 12
1
8