Acnodes FPC 7160 - Manual (Page 115)

661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
FPC 7160
15.6” Industrial Panel PC
B.3 Setup Procedure for Linux
The initial setup procedures for Linux system are mostly the same with the procedure for Microsoft
Windows. Please follow the steps below to setup recovery tool for Linux OS.
Step 1: Hardware and BIOS setup. Refer to Section B.2.1.
Step 2: Install Linux operating system. Make sure to install GRUB (v0.97 or earlier) MBR type and
Ext3 partition type. Leave enough space on the hard drive to create the recover partition later.
NOTE:
If the Linux OS is not installed with GRUB (v0.97 or earlier) and Ext3, the Symantec Ghost may not
function properly.
While installing Linux OS, please create two partitions:
Partition 1: /
Partition 2: SWAP
NOTE:
Please reserve enough space for partition 3 for saving recovery images.
Step 3: Create a recovery partition. Insert the recovery CD into the optical disk drive.
Follow Step 1 ~ Step 3 described in Section B.2.2. Then type the following commands (marked in red)
to create a partition for recovery images.