Acnodes FPC 7160 - Manual (Page 30)

661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
FPC 7160
15.6” Industrial Panel PC
If the FPC7160/ FPC 7162 fails to boot due to improper BIOS settings, the clear CMOS jumper clears
the CMOS data and resets the system BIOS information. To do this, use the jumper cap to close the pins
for a few seconds then remove the jumper clip.
If the "CMOS Settings Wrong" message is displayed during the boot up process, the fault may be
corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu. The clear
CMOS jumper settings are shown in Table 2-7.
The location of the clear CMOS jumper is shown in Figure 2-10 below.