Fpc 7160, 7 jumper settings – Acnodes FPC 7160 User Manual
Page 27
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
FPC 7160
15.6” Industrial Panel PC
2.7 JUMPER SETTINGS
NOTE:
A jumper is a metal bridge used to close an electrical circuit. It consists of two or three metal pins
and a small metal clip (often protected by a plastic cover) that slides over the pins to connect them.
To CLOSE/SHORT a jumper means connecting the pins of the jumper with the plastic clip and to
OPEN a jumper means removing the plastic clip from a jumper.
The following jumpers can be found on the motherboardinstalled in the FPC 7160/ FPC 7162. Before
the FPC7160/ FPC7162 is installed, the jumpers must be set in accordance with the desired
configuration. The jumpers on the FPC7160/ FPC7162 motherboard are listed in Table 2-4.