Acnodes FPC 7160 - Manual (Page 119)

661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
FPC 7160
15.6” Industrial Panel PC
B.5 Other Information
B.5.1 Using AHCI Mode or ALi M5283/ VIA VT6421A Controller
When the system uses AHCI mode or some specific SATA controllers such as ALi M5283 or VIA
VT6421A, the SATA RAID/AHCI driver must be installed before using one key recovery. Please follow
the steps below to install the SATA RAID/AHCI driver.
Step 1: Copy the SATA RAID/AHCI driver to a floppy disk and insert the floppy disk into a USB floppy
disk drive. The SATA RAID/AHCI driver must be especially designed for the on-board SATA controller.
Step 2: Connect the USB floppy disk drive to the system.
Step 3: Insert the One Key Recovery CD into the system and boot the system from the CD.
Step 4: When launching the recovery tool, press <F6>.
Step 5: When the following window appears, press <S> to select "Specify Additional Device".
Step 6: In the following window, select a SATA controller mode used in the system. Then press <En-
ter>. The user can now start using the SATA HDD.
Step 7: After pressing <Enter>, the system will get into the recovery tool setup menu. Continue to
follow the setup procedure from Step 4 in Section B.2.2 Create Partitions to finish the whole setup
process.
B.5.2 System Memory Requirement
To be able to access the recovery tool by pressing <F3> while booting up the system, please make
sure to have enough system memory. The minimum memory requirement is listed below.
Using Award BIOS: 128 MB system memory
Using AMI BIOS: 512 MB system memory.