Fpc 7160, 4 wall mounting – Acnodes FPC 7160 User Manual
Page 42
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
FPC 7160
15.6” Industrial Panel PC
To install the FPC7160/ FPC7162 on the arm, follow the directions below.
NOTE:
Make sure the arm supports standard VESA mounting. The FPC7160/ FPC 7162 uses a
VESA mounting to attach to the arm.
Step 1: The arm is purchased separately. Follow the instructions in the arm's user manual to securely
attach the arm to the wall.
Step 2: Once the mounting arm has been firmly attached to the surface, lift the flat panel PC onto the
interface pad of the mounting arm.
Step 3: Align the retention screw holes on the mounting arm interface with those in the flat panel PC.
The arm mount retention screw holes are shown in Figure 2-21.
Step 4: Secure the flat panel PC to the interface pad by inserting four retention screws through the
bottom of the mounting arm interface pad and into the flat panel PC.
2.8.4 WALL MOUNTING
To mount the flat panel PC onto the wall, please follow the steps below.