Fpc 7160 – Acnodes FPC 7160 User Manual
Page 46
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
FPC 7160
15.6” Industrial Panel PC
Step 3: Slide the flat panel PC through the hole until the aluminum frame is flush against the panel.
Step 4: Insert the panel mounting clamps into the pre-formed holes along the edges of the chassis,
behind the aluminum frame.
Step 5: Tighten the screws that pass through the panel mounting clamps until the plastic caps at the
front of all the screws are firmly secured to the panel (Figure 2-27).
2.8.6 Panel Mounting (FPC 7160 ONLY)
To mount the FPC7160 flat panel PC into a panel, please follow the steps below.
Step 1: Select the position on the panel to mount the flat panel PC.
Step 2: Cut out a section from the panel that corresponds to the rear panel dimensions of the flat panel
PC. Take care that the panel section that is cut out is smaller than the overall size of the metal frame that
surrounds the flat panel PC but just large enough for the rear panel of the flat panel PC to fit through.
Recommended cutout size shown below.