Garmin G1000 Mooney M20TN - Manual (Page 105)

190-00647-00 Rev. A Garmin G1000 Pilot’s Guide for the Mooney M20M/M20R/M20TN 4-25
AUDIO PANEL AND CNS
DME TUNING
NOTE: When turning on the G1000 for use, the system remembers the last frequency used for DME tuning
and the NAV1 , NAV2, or HOLD state prior to shutdown.
The DME transceiver is tuned by selecting NAV1, NAV2, or HOLD in the ADF/DME Tuning Window.
Figure 4-34 ADF/DME Tuning Window, DME Modes
DME
Modes
The following DME transceiver pairing can be selected:
• NAV1 – Pairs the DME frequency from the selected NAV1 frequency.
• NAV2 – Pairs the DME frequency from the selected NAV2 frequency.
• HOLD – When in the HOLD position, the DME frequency remains paired with the last selected NAV
frequency.
Selecting DME transceiver pairing:
1) Press the ADF/DME Softkey to display the ADF/DME Tuning Window.
2) Turn the small FMS Knob to select the DME tuning mode.
3) Press the ENT Key to complete the selection.
Pressing the CLR Key or FMS Knob while in the process of DME pairing cancels the data entry and reverts
back to the previously selected DME tuning state. Pressing the FMS Knob activates/deactivates the cursor in
the ADF/DME Tuning Window.