Garmin G1000 Mooney M20TN - Manual (Page 51)

190-00647-00 Rev. A Garmin G1000 Pilot’s Guide for the Mooney M20M/M20R/M20TN 2-5
FLIGHT INSTRUMENTS
VSPEED REFERENCES
NOTE: Refer to the AFMS for Vspeed values.
Vspeeds (Glide, V
R
, V
X
, and V
Y
) can be changed and their flags turned on/off from the Timer/References
Window. When active (on), the Vspeeds are displayed at their respective locations to the right of the airspeed
scale. By default, all Vspeed values are reset and all flags turned off when power is cycled.
Changing Vspeeds and turning Vspeed flags on/off:
1) Press the TMR/REF Softkey.
2) Turn the large FMS Knob to highlight the field of the desired Vspeed to be changed.
3) Use the FMS Knob to enter the desired value and press the ENT Key (when a speed has been changed from a
default value, an asterisk appears next to the speed).
4) With the flag ON/OFF field highlighted, turn the small FMS Knob clockwise to ON or counterclockwise to OFF.
5) To remove the window, press the CLR Key or the TMR/REF Softkey.
Figure 2-5 Timer/References Window Figure 2-6 Timer/References Menu
Turning all Vspeed flags on/off:
1) Press the TMR/REF Softkey.
2) Press the MENU Key.
3) To activate all Vspeed flags, press the ENT Key with ‘All References On’ highlighted.
4) To remove all Vspeed flags, turn the FMS Knob to highlight ‘All References Off’ and press the ENT Key.
Restoring all Vspeed defaults:
1) Press the TMR/REF Softkey.
2) Press the MENU Key.
3) Turn the FMS Knob to highlight ‘Restore Defaults’ and press the ENT Key.