Garmin G1000 Mooney M20TN User Manual
Page 228
5-110
190-00647-00 Rev. A
Garmin G1000 Pilot’s Guide for the Mooney M20M/M20R/M20TN
GPS NAVIGATION
8)
Highlight ‘LOAD?’ or ‘ACTIVATE?’. ‘LOAD’ adds the approach to the flight plan without immediately using the
approach for navigation guidance. This allows for the original flight plan to continue navigating until cleared
for the approach, but keeps the approach available for quick activation when needed. ‘ACTIVATE’ adds the
approach to the flight plan and begins navigating the approach course.
9)
If the approach is not approved for GPS, a ‘NOT APPROVED FOR GPS’ messages is displayed with ‘YES’
highlighted. Press the ENT Key to acknowledge the message. To cancel the approach, select ‘NO’ and press
the ENT Key.
OR:
1)
From the Active Flight Plan Window, press the MENU Key.
2)
Highlight ‘Load Approach’
3)
Press the ENT Key. The APPROACH window is displayed on the ‘PROC – APPROACH LOADING’ Page.
4)
Select an approach and press the ENT Key. The TRANSITION window is displayed.
5)
Select a transition (the ‘VECTORS’ option assumes vectors will be received to the final course segment of the
approach and will provide navigation guidance relative to the final approach course).
6)
Press the ENT Key.
7)
Highlight ‘LOAD?’ or ‘ACTIVATE?’. ‘LOAD’ adds the approach to the flight plan without immediately using the
approach for navigation guidance. This allows for the original flight plan to continue navigating until cleared for
the approach, but keeps the approach available for quick activation when needed. ‘Activate’ adds the approach
to the flight plan and begins navigating the approach course.
8)
If the approach is not approved for GPS, a ‘NOT APPROVED FOR GPS’ messages is displayed with ‘YES’
highlighted. Press the ENT Key to acknowledge the message. To cancel the approach, select ‘NO’ and press
the ENT Key.
Removing an approach from a direct-to or active flight plan:
1)
From the Flight Plan Window, press the MENU Key.
2)
Highlight ‘Remove Departure’, ‘Remove Arrival’, or ‘Remove Approach’
3)
Press the ENT Key. A confirmation window appears listing the procedure that is about to be removed with ‘OK’
highlighted.
4)
Press the ENT Key.