Garmin G1000 Mooney M20TN - Manual (Page 61)

190-00647-00 Rev. A Garmin G1000 Pilot’s Guide for the Mooney M20M/M20R/M20TN 2-15
FLIGHT INSTRUMENTS
Changing the selected GPS CDI setting:
1) Use the FMS Knob to select the AUX - System Setup Page on the MFD.
2) Press the FMS Knob to activate the cursor.
3) Turn the large FMS Knob to highlight the ‘Selected’ field in the ‘GPS CDI’ Box.
4) Turn the small FMS Knob to highlight the desired setting and press the ENT Key.
Figure 2-21 System Setup Page,
GPS CDI Settings
BEARING POINTERS AND INFORMATION WINDOWS
NOTE: When the Arc HSI is displayed, the Bearing Information Windows and pointers are disabled.
NOTE: Refer to the Audio Panel and CNS Section for information on tuning the radios.
NOTE: ADF radio installation is optional.
Two bearing pointers and associated information can be displayed on the HSI by pressing the PFD Softkey
then a BRG Softkey. Use the BRG Softkey to cycle through bearing sources (NAV, GPS, ADF). The pointers
are light blue and are single- (BRG1) or double-lined (BRG2); an icon is shown in the respective information
window to indicate the pointer type. The bearing pointers never override the CDI and are visually separated
from the CDI by a white ring (shown when bearing pointers are selected but not necessarily visible due to
data unavailability).
When a bearing pointer is displayed, its associated information window is also displayed. The Bearing
Information Windows are displayed to the lower sides of the HSI and show:
• Bearing source (NAV, GPS, ADF)
• Pointer icon (single line for BRG1, double line for BRG2)
• Frequency (NAV, ADF)
• Station/waypoint identifier (NAV, GPS)
• GPS-derived great circle distance to bearing source