Audio panel and cns – Garmin G1000 Mooney M20TN User Manual
Page 83
190-00647-00 Rev. A
Garmin G1000 Pilot’s Guide for the Mooney M20M/M20R/M20TN
4-3
AUDIO PANEL AND CNS
1
NAV VOL/ID Knob – Controls NAV audio volume level. Press to turn the Morse code identifier audio on
and off. Volume level is shown in the NAV frequency field as a percentage.
2
NAV Frequency Transfer Key – Transfers the standby and active NAV frequencies.
3
NAV Knob – Tunes the standby frequencies for the NAV receiver (large knob for MHz; small knob for kHz).
Press to move the tuning box (cyan box) and Frequency Transfer Arrow between NAV1 and NAV2.
4
NAV Frequency Box – Displays NAV standby and active frequency fields, volume, and station ID. The
frequency of the NAV radio selected for navigation is displayed in green.
5
COM Frequency Box – Displays COM standby and active frequency fields and volume. The selected COM
transceiver frequency is displayed in green.
6
COM Knob – Tunes the standby frequencies for the COM transceiver (large knob for MHz; small knob
for kHz). Press to move the tuning box (cyan box) and Frequency Transfer Arrow between COM1 and
COM2.
7
COM Frequency Transfer Key – Transfers the standby and active COM frequencies. Press and hold this key
for two seconds to tune the emergency frequency (121.500 MHz) automatically into the active frequency
field.
8
COM VOL/SQ Knob – Controls COM audio volume level. Press to turn the COM automatic squelch on
and off. Volume level is shown in the COM frequency field as a percentage.
9
ADF/DME Tuning Window – Displays ADF and DME frequencies, volume setting, and modes. Display by
pressing ADF/DME Softkey.
10
ENT Key – Validates or confirms an ADF frequency or ADF/DME mode and Auto-tune selection.
11
FMS Knob – Flight Management System Knob, used to enter ADF frequencies and select ADF/DME
modes and Auto-tune entries when ADF/DME Tuning Window is present. Press the FMS Knob to turn
the selection cursor on and off. The large knob moves the cursor in the window. The small knob selects
individual characters for the highlighted cursor location.
12
Transponder Data Box – Indicates the selected transponder code, operating mode, reply, and ident status
for the transponder.