Ils approach, Automatic flight control system, Flying an ils approach – Garmin G1000 Mooney M20TN User Manual
Page 326: Push the ap disc switch and land the aircraft, Figure 7-26 ils approach to kfat
190-00647-00 Rev. A
Garmin G1000 Pilot’s Guide for the Mooney M20M/M20R/M20TN
7-26
AUTOMATIC FLIGHT CONTROL SYSTEM
ILS APPROACH
Flying an ILS approach:
1)
Transition from GPS Navigation Mode to Heading Select Mode.
a)
Load the Runway 29R ILS approach for KFAT into the Flight Plan and select ‘Vectors to Final’ for the transition.
b)
Set the Selected Heading after getting vectors from ATC and press the HDG Key. The autopilot turns the aircraft
to the desired heading.
2)
Use Heading Select Mode to comply with ATC vectors as requested.
3)
In preparation for approach, tune the localizer frequency and select LOC mode on the HSI.
4)
Press the APR Key when cleared for approach to arm LOC Approach and Glideslope modes.
The autopilot and flight director determine when to begin the turn to intercept the final approach course.
5)
The autopilot flies the ILS Approach. At the Decision Height, there are two options:
a)
Push the AP DISC Switch and land the aircraft
OR
:
b)
Use the Go Around Switch to execute a missed approach (refer to the following procedure).
0
0
3
3
6
6
9
9
12 12
2
1 15
5
1 18
8
21 21
1
2 24
4
2727
2
30
30
30
33
33
3
122
KFAT
Clovis
VORTAC
(CZQ)
111
291
075
025
HDG Mode
GPS Course
LOC APR/
GS Mode
SANGO
1
2
3
4
5
GPS NA
V Mode
Figure 7-26 ILS Approach to KFAT