Garmin G1000 Mooney M20TN - Manual (Page 146)

5-28
GPS NAVIGATION
190-00647-00 Rev. A Garmin G1000 Pilot’s Guide for the Mooney M20M/M20R/M20TN
5.3 DIRECT-TO-NAVIGATION (MFD)
The “direct-to” navigation feature provides a quick method of setting a GPS course to a destination waypoint.
Once a direct-to is activated, the G1000 establishes a point-to-point course line from the present position to
the selected direct-to destination. Course guidance is provided until the direct-to is cancelled or replaced by a
new destination.
Figure 5-22 MFD Direct to Window
Direct-To Waypoint
Identifier, Facility,
Symbol, City
Activate Annunciation
Inset Map Showing
Direct-To Waypoint
Location
Bearing to Waypoint
from Present Position
Flight Plan
Waypoints
Nearest Waypoints
Direct to Waypoint
Location
Course to Waypoint
from Present Position
Direct to Waypoint
Location
Bearing to Waypoint
from Present Position
NOTE: The Direct-to Window Inset Map (Figure 5-22) range is adjustable. To change the map range, turn the
joystick to the left to select a lower range, turn it to the right to select a higher range.
Entering a Direct-to destination:
1) Press the Direct-to Key.
2) Enter the destination waypoint (identifier, facility, or city).
3) Press the ENT Key to confirm the entry. The ‘Activate?’ field is highlighted.
4) Press the ENT Key to highlight ‘Activate?’ or turn the large FMS Knob to highlight the ‘COURSE’ field.
5) Enter the desired course to the waypoint.
6) Press the ENT Key to highlight ‘ACTIVATE?’.
7) Press the ENT Key again to activate the Direct-to.