Garmin G1000 Mooney M20TN - Manual (Page 63)

190-00647-00 Rev. A Garmin G1000 Pilot’s Guide for the Mooney M20M/M20R/M20TN 2-17
FLIGHT INSTRUMENTS
2.3 SUPPLEMENTAL FLIGHT DATA
NOTE: Pressing the DFLTS Softkey (a second-level PFD softkey) turns off metric Altimeter display and the
Inset Map. Pressing this softkey does not restore display units to the default settings.
Some displayed information disappears when pitch exceeds +30˚/-20˚ or bank exceeds 65˚. The Altimeter and
Airspeed, Attitude, Vertical Speed, and Horizontal Situation indicators remain on the display and the Bearing
Information and Annunciation windows can be displayed during such situations.
The following information is removed from the PFD (and corresponding softkeys are disabled) when the aircraft
experiences unusual attitudes:
• Traffic Annunciations
• AFCS Annunciations
• Flight director Command Bars
• Inset Map
• Outside Air Temperature
• DME Information Window
• Transponder Data Box
• System Time
• PFD Setup Menu
• Windows displayed in the lower right corner
• Barometric Minimum Descent Altitude Box
• Vertical Deviation/Glideslope Indicator
• Altimeter Barometric Setting
• Selected Altitude
TIMER/REFERENCES WINDOW
NOTE: Refer to Section 2.2 under the Airspeed Indicator discussion for information on Vspeeds and Section
2.4 for information on the barometric minimum descent altitude.
The Timer/References Window is enabled/disabled in the lower right corner of the PFD by selecting the TMR/
REF Softkey. This window provides access to the following settings:
• Generic Timer
• Vspeeds values and flags
• Barometric minimum descent altitude (MDA, DH)
Figure 2-23 Timer/References Window