Garmin G1000 Mooney M20TN - Manual (Page 64)

Garmin G1000 Pilot’s Guide for the Mooney M20M/M20R/M20TN 190-00647-00 Rev. A 2-18
FLIGHT INSTRUMENTS
GENERIC TIMER
The PFD generic timer can be set to count up or down from a specified time (HH:MM:SS). When the
countdown on the timer reaches zero the digits begin to count up from zero. If the timer is reset before
reaching zero on a countdown, the digits are reset to the initial value. If the timer is counting up when reset,
the digits are zeroed.
Setting the generic timer:
1) Press the TMR/REF Softkey.
2) Turn the large FMS Knob to select the time field (hh/mm/ss).
3) Use the FMS Knob to enter the desired time and press the ENT Key.
4) With the UP/DN field highlighted, turn the small FMS Knob to select the timer counting direction.
5) Press the ENT Key.
6) With ‘START?’ highlighted, press the ENT Key to start the timer. The field changes to ‘STOP?’.
7) To stop the timer, press the ENT Key with ‘STOP?’ highlighted. The field changes to ‘RESET?’.
8) To reset the timer, press the ENT Key with ‘RESET?’ highlighted. The field changes back to ‘START?’ and the
digits are reset.
9) To remove the window, press the CLR Key or the TMR/REF Softkey.
OUTSIDE AIR TEMPERATURE
The Outside Air Temperature (OAT) is displayed in degrees Celsius (°C) by default in the lower left of the PFD
under normal display conditions, or below the true airspeed in reversionary mode.
Figure 2-24 Outside Air Temperature
Normal Display Reversionary Mode
Changing temperature display units:
1) Select the AUX - System Setup Page using the FMS Knob.
2) Press the FMS Knob to activate the cursor.
3) Turn the large FMS Knob to highlight the TEMP field.
4) Turn the small FMS Knob to select the desired unit.
5) Press the ENT Key to confirm selection.